OEM Integra Type R rear wing
into Integra GS-R / LS hatchback
DC2
Integra Type R 1997-2001
→
DC2
Integra GS-R / LS hatchback 1994-2001
Yes: the OEM Integra Type R rear wing from the Integra Type R (1997-2001) fits the Integra GS-R / LS hatchback (1994-2001) — easy difficulty, modifications required.
Verdict
Fits.
Verified entry
· modifications required
Verified ✓
Difficulty
Easy
Mods
Required
Category
Exterior
Installation notes
Yes — the OEM rear wing from a 1997–2001 Integra Type R (DC2) bolts onto a 1994–2001 Integra GS-R or LS hatchback (DC2) using the existing holes, with no drilling. Honda-Tech members say the GS-R hatch has the same mounting holes plus a few extra, so two holes are left exposed and must be plugged or welded. Because the GS-R wing carries the third brake light, removing it means adding a separate third brake light.
ModsMods req.
Required modifications
The Type R wing uses four hatch holes (two each side); the GS-R/LS wing uses six, including a hole of about 1 inch for the wing brake-light wiring and a smaller one of about 3/8 inch. Plug the exposed holes (one owner used 7/8-inch and 7/16-inch nylon plugs with clear silicone) or weld them shut. Fit with double-sided tape and four 10 mm nuts.
Caution
Important caveats
- Two holes are left exposed on the hatch, including the roughly 1-inch brake-light wiring hole; seal them to keep water out.
- The GS-R wing's built-in third brake light is lost; fit a separate one (owners suggest one from an RS).
- Hatches that never had a wing will need holes drilled; the sources only cover hatches with a factory wing.
- Members say aftermarket replica Type R wings do not fit as well as the OEM part.
No guide yet — write one or browse all guides.
Reference
Done this swap?
Verify it and help the next builder.
Verified by 0 builders
Sources
2 refs
Submitted by
FitMyBuild research
Added
Updated
Comments
(0)Sign in to join the discussion.
Please verify your email to post comments.
No comments yet. Be the first to share your experience.